Editing A Protocol Error Threshold - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

Editing a Protocol Error threshold

To edit a Protocol Error threshold, complete the following steps.
1. Select Configure > Port Fencing.
2. Select Protocol Error from the Violation Type list.
3. Select the threshold you want to change and click Edit.
4. Change the name for the threshold in the Name field, if necessary.
5. (M-EOS devices only) Change the M-EOS Protocol Error thresholds by completing the following
6. (Fabric OS devices only) Change the Fabric OS Protocol Error thresholds by completing the
7.
8. Click OK on the Port Fencing dialog box.
DCFM Enterprise User Manual
53-1001775-01
The Port Fencing dialog box displays.
The Edit Protocol Error Threshold dialog box displays.
FIGURE 138
Edit Protocol Error Threshold dialog box
steps.
a. Change the number of protocol errors allowed for the threshold from the Threshold errors
list, if necessary.
b. Change the time period for the threshold (in minutes) from the errors per list, if necessary.
following steps.
a. Select one of the following options:
•
Default—Uses device defaults. Go to
•
Custom—Uses your selections. Continue with
b. Change the number of protocol errors allowed for the threshold from the Threshold errors
list, if necessary.
c. Change the time period for the threshold from the errors per list, if necessary.
Click OK on the Edit Protocol Error Threshold dialog box.
If the threshold has already been assigned to ports, an "Are you sure you want to make the
requested changes to this threshold on "X" ports?" message displays. Click OK to close.
To assign this threshold to fabrics, switches, or switch ports, refer to
page 339.
Editing a Protocol Error threshold
step 7.
step b.
"Assigning thresholds"
13
on
345