6
Basic I/O Configuration Information
Introduction
This chapter provides information about the I/O functions and capabilities of the server. Operating
restrictions and methodologies are described.
COM1/2 Ports
The COM1 serial port is not accessible. This internal port is intended for factory use only. The COM2 serial
port is located on the server rear panel. Serial over LAN should be set to 19.2 kbps for best/consistent data
flow.
RJ-45 Serial Ports
7
The front and rear serial ports have
different connector pin arrangements and
require different serial cables. Refer to
Connector Pinouts in Chapter 1
112
Chapter 8