HP Carrier-grade cc2300 Product Manual page 102

Figure 11-13. Disengaging the Retention Clips from the Processor Socket
6. Remove the second retention clip as described in the preceding steps.
Use care when handling the heatsink. Protect the fans and thermal pad. Do not scratch or
CAUTION
otherwise damage the black thermal pad. Failure to heed this notice may result in decreased
cooling efficiency and damage.
7. Lift the processor heatsink from the RM bracket and processor.
8. Raise the locking bar on the socket (Figure 11-8), and lift the processor from the socket.
9. A new thermal pad is provided with replacement processors. Discard the old thermal pad after locating
the replacement.
10. Follow the instructions packaged with the processor to be installed. Instructions are provided for
preparation of the heatsink and processor for installation.
11. Observe the triangular symbols on the socket and on the processor to be installed. Orient the processor
such that the triangular symbols are aligned.
12. Aligning the pins of the processor with the socket, insert the processor into the socket. (See Figure 11-9.)
Ensure that the pins are fully inserted and that the processor is flush against the socket.
13. Lower the locking bar completely, to lock the processor pins into the socket. (See Figure 11-10.)
14. Position the heatsink above the processor, ensuring that the black thermal pad is positioned directly
over the processor, and the heatsink is oriented such that it will fit into the retainer.
15. Aligning the raised metal surfaces, lower the heatsink into position, on top of the processor. (See Figure
11-11.)
16. Place one heatsink clip in position, so the tab on the clip engages the slot on the heatsink (A in Figure
11-12). Position the clip so that the plastic tab on the retaining bracket is located in the narrow portion
of the heatsink clip opening.
17. Press one end of the clip down until it locks into position in the retainer. (B in Figure 11-12). Ensure that
the plastic tab on the RM bracket protrudes through the corresponding opening in the heatsink clip.
Some sideways movement of the clip may be necessary to achieve proper installation.
102 Chapter 8