Vrrp Vrid Authentication-Mode - HP 6125XLG Command Reference Manual

Default
VRRPv3 is used.
Views
Interface view
Predefined user roles
network-admin
Parameters
version-number: Specifies a VRRP version. The version number is 2 or 3, where 2 indicates VRRPv2
(described in RFC 3768), and 3 indicates VRRPv3 (described in RFC 5798).
Usage guidelines
The version of VRRP on all routers in an IPv4 VRRP group must be the same.
Examples
# Specify VRRPv2 to run on VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] vrrp version 2

vrrp vrid authentication-mode

Use vrrp vrid authentication-mode to configure the authentication mode and the authentication key for
an IPv4 VRRP group to send and receive VRRP packets.
Use undo vrrp vrid authentication-mode to restore the default.
Syntax
vrrp vrid virtual-router-id authentication-mode { md5 | simple } { cipher | plain } key
undo vrrp vrid virtual-router-id authentication-mode
Default
Authentication is disabled when a VRRP group sends and receives VRRP packets.
Views
Interface view
Predefined user roles
network-admin
Parameters
virtual-router-id: Specifies an IPv4 VRRP group by its virtual router ID in the range of 1 to 255.
md5: Specifies the MD5 authentication mode.
simple: Specifies the simple authentication mode.
cipher: Sets a ciphertext authentication key.
plain: Sets a plaintext authentication key.
73