Vrrp Commands; Ipv4 Vrrp Commands; Display Vrrp - HP 6125XLG Command Reference Manual

Blade switch high availability command reference
Table of Contents

Advertisement

VRRP commands

IPv4 VRRP commands

The interfaces that VRRP involves can be only Layer 3 Ethernet interfaces and VLAN interfaces unless
otherwise specified. You can configure an Ethernet port as a Layer 3 interface by using the port
link-mode route command (see Layer 2—LAN Switching Configuration Guide).

display vrrp

Use display vrrp to display the states of IPv4 VRRP groups.
Syntax
display vrrp [ interface interface-type interface-number [ vrid virtual-router-id ] ] [ verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number.
vrid virtual-router-id: Specifies an IPv4 VRRP group by its virtual router ID in the range of 1 to 255.
verbose: Displays detailed IPv4 VRRP group information. If the verbose keyword is not specified, this
command displays brief IPv4 VRRP group information.
Usage guidelines
If no interface or VRRP group is specified, this command displays the states of all IPv4 VRRP groups. If
only an interface is specified, this command displays the states of all IPv4 VRRP groups on the specified
interface. If both an interface and an IPv4 VRRP group are specified, this command displays the states of
the specified IPv4 VRRP group on the specified interface.
Examples
# Display brief information about all IPv4 VRRP groups on the device when VRRP operates in standard
mode.
<Sysname> display vrrp
IPv4 Virtual Router Information:
Running Mode
Total number of virtual routers : 1
Interface
---------------------------------------------------------------------
Vlan2
: Standard
VRID
State
1
Master
Running Adver
Auth
Pri
Timer
Type
150
100
Simple
61
Virtual
IP
1.1.1.1

Advertisement

Table of Contents
loading

Table of Contents