Display Brightness Control; Sound Mode - Sharp HT-SB60 Operation Manual

General control (continued)
●
When pairing is successful:
On sound bar: "PAIRING" disappears.
On subwoofer: indicator turns blue.
Sound Bar
Notes:
●
If a device such as microwave oven, wireless LAN card,
Bluetooth device or any other device that uses the
same 2.4GHz frequency near the system, some sound
interruption may be heard due to interference.
●
The transmission distance of the wireless signal
between the subwoofer and sound bar is about 10m,
but may vary depending
environment. If a steel-concrete or metallic wall is
between the subwoofer and the sound bar, the system
may not operate at all, because the wireless signal
cannot penetrate metal.
Caution:
●
Keep the subwoofer away from water and moisture.
●
To get the optimum listening performance, make sure
the area around the sound bar and subwoofer is clear
of any obstacles.

Display brightness control

Press the DIMMER button to adjust the brightness of the
display.
(Display is dim)
Dimmer 1
Dimmer 2
(Display gets dimmer)
Dimmer Off (Display is bright)
Volume auto fade-in
If you turn off and on the sound bar with the volume set to
80 or higher, the volume starts at 40 and fades in to the last
set level.
Volume control
Sound bar operation:
Press the VOLUME +
button to increase the
volume and the VOLUME –
button for decreasing.
Remote control operation:
Press the VOL + button to increase the volume and the
VOL – button to decrease the volume.
Subwoofer
PAIRING
on your operating
.....
Min Max
1 2 99
Muting
The volume is muted temporarily when pressing the
button on the remote control. Press again to restore the volume.
Note:
When the sound bar is turned off and back on again,
muting is cancelled.

Sound Mode

Sound bar operation:
To change to a different mode, press the SOUND MODE
button repeatedly until the desired sound mode is
displayed.
Remote control operation:
Press the desired sound mode button on the remote
control.
CINEMA
MUSIC
GAME
SPORT
NEWS
NIGHT
BYPASS
Bass and Treble Control
Bass and Treble control is applicable during BYPASS
mode only.
Bass Control
1. Press the BASS button.
2. Within 5 seconds, press the VOL (+ or –) button to adjust
the bass.
Treble Control
1. Press the TREBLE button.
2. Within 5 seconds, press the VOL (+ or –) button to adjust
the bass.
Subwoofer level control
The subwoofer level can be
adjusted.
To increase
the
press the SW LEVEL
button.
To decrease the level, press the SW LEVEL
Notes:
●
When sound from the speaker is distorted, decrease
the subwoofer level.
●
When changing the subwoofer level, the output level of
the subwoofer is also changed.
AV SYNC level control
The AV SYNC (Audio Video
Synchronization) level can
be adjusted.
To increase the level, press
the AV SYNC + button.
To decrease the level, press the AV SYNC – button.
E-11
(for cinema sound effect)
(for standard sound effect)
(for game sound effect)
(for sport broadcasting)
(for news)
(for night)
(for flat sound effect)
level,
.....
–5 –4 +4
.....
0 +1 +3
(MUTE)
+5
button.