Installation; Install Thermostat - Robertshaw 9500 User Manual

4. After labeling wires, remove wires from terminals.
5. Remove existing thermostat base from wall.
6. Refer to the following section for instructions on how to

install thermostat.

Installing Model 9500 Thermostat
NOTE: F
OR NEW INSTALLATIONS
D
O NOT INSTALL BEHIND A DOOR
HEAT OR STEAM GENERATING FIXTURES
.
OPERATION
1. Turn power off to the heating
and cooling systems.
2. Place COOL-OFF-HEAT
In OFF position.
3. Place
Into AUTO position.
4. Remove the cover using a coin
or screwdriver.
5. Place thermostat against the wall at desired location. Make sure
wires will feed through opening on base of thermostat.
,
MOUNT THERMOSTAT ON INSIDE WALL
,
IN A CORNER
. I
NSTALLATION AT THESE PLACES WILL AFFECT THERMOSTAT
COOL OFF HEAT AUTO - ON
AUTO-ON switch
, ,
NEAR AIR VENTS IN DIRECT SUNLIGHT
3
, 4-5
FEET ABOVE THE FLOOR
,
OR NEAR ANY
COOL OFF HEAT
AUTO - ON
Figure 2
.