Yamaha MOXF8 Reference Manual page 149

VOICE PERF
NOTE
When setting the MOXF6/MOXF8 so that Arpeggio playback is synchronized to an external MIDI clock, make sure to set the
devices so that the MIDI clock from the DAW software/ external MIDI device is properly transmitted to the MOXF6/MOXF8 from
the DAW software/ external MIDI devices.
ClockOut
Determines whether MIDI clock (F8) messages will be transmitted via the MIDI OUT/USB terminal.
Settings:
off, on
SeqCtrl (Sequencer Control)
Determines whether Sequencer Control signals — start, continue, stop, and song position pointer — will be received
and/or transmitted via MIDI.
Settings:
off, in, out, in/out
off....................... Not transmitted/recognized.
in........................ Recognized, but not transmitted.
out...................... Transmitted, but not recognized.
in/out.................. Transmitted/recognized.
MTC StartOffset
Determines the specific time code point from which sequence playback starts, when MTC is received. This feature can
be used to accurately align playback of this synthesizer with an external MTC-compatible device.
Settings:
Hour: Minute: Second: Frame
Hour: 00 – 23
Minute: 00 – 59
Second: 00 – 59
Frame: 00 – 29
[SF4] OTHER
MIDI IN/OUT
Determines which physical output/input terminal(s) will be used for transmitting/receiving MIDI data.
Settings:
MIDI, USB
NOTE
The two types of terminals above cannot be used at the same time. Only one of them can be used to transmit/receive MIDI data.
BulkInterval
Determines the interval time of the Bulk Dump transmission when the Bulk Dump function is used or the Bulk Dump
Request is received.
Settings:
0 – 900 ms
MOXF6/MOXF8 Reference Manual
SONG PATTERN MIX MASTER REMOTE UTILITY QUICK SET FILE
Utility Mode
[F1] GENERAL
[F2] VOICE
[F2] SEQ
[F3] VCE A/D
[F4] CTL ASN
[F5] USB I/O
[F6] MIDI
Utility Job
149