Grandstream Networks GXP1100 User Manual page 32

No Key Entry Timeout (s)
Use # as Dial Key
G723 Rate
G.726-32 Packing Mode
iLBC Frame Size
iLBC Payload Type
Jitter Buffer Type
Jitter Buffer Length
Use Privacy Header
Use P-Preferred-Identity
Header
Special Feature
FIRMWARE VERSION 1.0.4.23
For end users, it is recommended to use the default setting, as incorrect
settings may influence the audio quality.
Defines the timeout (in seconds) for no key entry. If no key is pressed
after the timeout, the digits will be sent out. The default value is 4
seconds.
Allows users to configure the "#" key as the "Send" key. If set to "Yes",
the "#" key will immediately dial out the input digits. In this case, this key
is essentially equivalent to the "Send" key. If set to "No", the "#" key is
included as part of the dialing string.
Selects encoding rate for G723 codec. The default value is 5.3kbps.
Select "ITU" or "IETF" for G726-32 packing mode.
Selects iLBC packet frame size. The default value is 30ms.
Specifies iLBC Payload type. The default value is 97. The valid range is
between 96 and 127.
Selects either Fixed or Adaptive based on network conditions. The
default setting is "Adaptive".
Selects Low, Medium, or High based on network conditions. The default
setting is "Medium".
Controls whether the Privacy Header will present in the SIP INVITE
message or not. The default setting is "default", which is when "Huawei
IMS" special feature is on, the Privacy Header will not show in INVITE. If
set to "Yes", the Privacy Header will always show in INVITE. If set to
"No", the Privacy Header will not show in INVITE.
Controls whether the P-Preferred-Identity Header will present in the SIP
INVITE message or not. The default setting is "default", which is when
"Huawei IMS" special feature is on, the P-Preferred-Identity Header will
not show in INVITE. If set to "Yes", the P-Preferred-Identity Header will
always show in INVITE. If set to "No", the P-Preferred-Identity Header
will not show in INVITE.
Different soft switch vendors have special requirements. Therefore users
may need select special features to meet these requirements. Users can
choose from Standard, Nortel MCS, Broadsoft, CBCOM, RNK, Sylantro
or Huawei IMS depending on the server type. The default setting is
"Standard".
GXP1100/GXP1105 USER MANUAL Page 32 of 46