Table of Contents
Advertisement
5
After selecting or entering a value, press
[START/COPY].
6
Repeat steps 4 and 5 as needed.
7
When the operation is complete, press [STOP].
Registration ends and the FAXPHONE returns to
standby mode.
After 60 seconds of no operation panel input, the FAXPHONE returns
to standby mode and any unregistered changes are lost.
Entering a number _______________________________
Whenever you are prompted to enter a fax number or a telephone number, follow these
procedures.
Use the numeric buttons to enter the number.
TEL=
You can enter up to 20 digits for your fax number or 50 digits for a speed dialing
number.
Be sure to enter 1 and the area code, if necessary, to dial a different area code.
Do not enter dashes, slashes, commas, or other punctuation.
Use the One-touch Speed Dialing buttons as follows:
To enter a space between numbers, press [SPACE].
If you make a mistake, press [CLEAR] and enter the number
again.
To erase a previously registered number, press [CLEAR]. You
can also enter a new number over the old one.
If you need to enter a pause for any reason,
Press [REDIAL/PAUSE] at the desired point in the sequence when entering a series
of digits.
A pause within a number is 2 seconds long. The length of this pause can be
adjusted. See MID PAUSE SET in TX SETTINGS, p. 76. A pause at the end of a
number is fixed at 10 seconds.
Registering your name and number
DATA ENTRY OK
2
33
Advertisement
Table of Contents
