Removing A Memory Module - Toshiba R10 User Manual

■
The slot A is reserved for the first memory module. Use the slot B for
expanded memory. If only one module is installed, use the slot A.
■
Align the grooves along the edges of the memory module with the
latches on the connector and insert the module into the connector
firmly - if you find it difficult to install the memory module, gently prise
the locking tabs outwards using the tip of your finger.
Please also ensure that you hold the memory module along its left and
right hand edges - the edges with the grooves in.
8. Seat the memory module cover in place and secure it with two screws.
Take care to ensure that the memory module cover is firmly closed.
9. Install the battery pack - refer to
Chapter 6, Power and Power-Up Modes, if required.
10. Turn your computer over.
11. Turn the computer on and make sure the added memory is recognized
- to confirm it, Start -> Control Panel -> System and Maintenance
-> System icon.

Removing a memory module

To remove the memory module, follow the steps as detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
Modes, if required).
5. Loosen the two screws securing the memory module cover in place -
please note that this screw is attached to the cover in order to prevent it
from being lost.
User's Manual
Screws
Figure 3-9 Seating the memory module cover
Turning off the power
Hardware, Utilities and Options
Replacing the battery pack
section in Chapter 1, Getting Started if
section in Chapter 6, Power and Power-Up
Memory
module cover
section in
3-25