Lenovo 10A2 User Manual page 94

1. Install the solid-state drive into the adapter. Then, install the four screws to secure the solid-state
drive to the adapter.
Figure 85. Installing the solid-state drive into the adapter
2. To install the adapter with a solid-state drive into the blue bracket, flex the bracket and align pin
2 , pin 3 , and pin 4
board 5 on the bottom of the solid-state drive.
Figure 86. Installing the adapter with a solid-state drive into the bracket
3. Install the solid-state drive assembly into the hard disk drive bay. See "Replacing the primary hard
disk drive" on page 72.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 103.
82
ThinkCentre M83, M93/p User Guide
on the bracket with the corresponding holes in the adapter. Do not touch the circuit
1 , pin