10. Install the two screws that came with the mSATA solid-state drive to secure the drive to the storage
converter.
Figure 54. Installing the screws to secure the mSATA solid-state drive
11. Install the new mSATA solid-state drive into the card reader drive bay until it snaps into position. Then,
push the new mSATA solid-state drive to the left until the screw hole in the metal bracket of the mSATA
solid-state drive is aligned with the corresponding hole in the chassis.
Figure 55. Installing the mSATA solid-state drive into the chassis
12. Reconnect the signal cable and the power cable to the rear of the storage converter.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 103.
.
Chapter 5
Installing or replacing hardware
61