Lenovo 10A2 User Manual page 109

Installing the rear Wi-Fi antenna
Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
To install the rear Wi-Fi antenna, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 36.
3. Align the rear Wi-Fi antenna cable connector
Then, insert the rear Wi-Fi antenna cable connector into the hole.
Figure 109. Installing the rear Wi-Fi antenna cable connector
4. Install the rear Wi-Fi antenna washer
cable connector 1
Figure 110. Installing the nut and washer to secure the rear Wi-Fi antenna cable connector
2 and rear Wi-Fi antenna nut
on the Wi-Fi adapter card.
1
with the hole in the Wi-Fi antenna adapter as shown.
3
Chapter 5
to secure the rear Wi-Fi antenna
.
Installing or replacing hardware
97