Lenovo 10A2 User Manual page 61

7. Install the new card reader assembly into the card reader drive bay until it snaps into position. Then,
push the new card reader assembly to the left until the screw hole in the metal bracket of the card
reader assembly is aligned with the corresponding hole in the chassis.
Figure 32. Installing the card reader assembly
8. Install the screw to secure the card reader assembly to the chassis.
Figure 33. Installing the screw to secure the card reader assembly
9. Connect the cable of the new card reader assembly to the front USB connector 1 on the system board.
See "Locating parts on the system board" on page 14
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 103.
.
Chapter 5 Installing or replacing hardware
49