Setting The Assisted Cleaning Cycle - Smeg SAP112-8 Operation And Installation Instructions Manual

• Spray a water and washing up liquid
solution inside the oven using a spray
nozzle. Aim the spray towards the side
walls, roof, floor and deflector (the
coloured zone on the illustration to the
side shows where the solution can be
sprayed).
Do not spray excessive amounts of the water and washing up liquid solution. We
recommend spraying approx. 20 times at the most.
• Close the door and set the assisted
cleaning cycle.

8.8.2 Setting the assisted cleaning cycle

The assisted cleaning cycle can be only be activated when the oven is cold. If it
is activated when the inside of the oven is still hot, the word STOP will appear on
the display.
In ON mode (see 6.5 Operating modes), turn the
ON/OFF knob right or left to select the VAPOR
CLEAN
To start the cleaning cycle (VAPOR CLEAN), the
temperature selection knob must be pressed.
will light up to show that the cleaning phase is in
progress.
The display will show the temperature at which the cleaning cycle is taking place
and the remaining time.
54
Instructions for the User
cleaning cycle.
(ON-OFF knob)
(Temperature knob)