Setting The Cleaning Cycle - Smeg SAP112-8 Operation And Installation Instructions Manual

Instructions for the User

8.7.2 Setting the cleaning cycle

In ON mode (see 6.5 Operating modes), turn the
ON/OFF knob right or left to select one of the two
cleaning cycles out of
To start the cleaning
temperature selection knob must be pressed.
will light up to indicate that it is now possible to set
the cycle duration.
Turn the knob right or left to increase or decrease the
duration of the cycle between a minimum of 1h 30m
and a maximum of 3h 00m (apart from the
where the duration is set at 1h 30m).
The text "Piro" will appear on the display to indicate
that the oven is performing the cleaning cycle.
The time remaining to the end of the cleaning cycle
will also be shown.
Two minutes after the cleaning cycle (Pyrolysis)
starts an interlock device which prevents opening of
the door will be tripped.
that the locking device has been activated.
At the end of the cleaning cycle, the locking device
will remain active until the temperature inside the
oven has reached a safety threshold. When the oven
has cooled down, collect the residues from
automatic cleaning with a damp microfibre cloth.
and .
cycle (pyrolysis),
will light up to indicate
(ON-OFF knob)
the
(Temperature knob)
cycle
(Temperature knob)
51