Removing Guide Frames - Smeg SAP112-8 Operation And Installation Instructions Manual

Instructions for the User
Lift up the edge of the lower
heating element a few centimetres
and clean the bottom.
Put the pizza plate support back in
place, pushing it in until it hits the
back of the oven, and push it down
so that the heating element plate
is embedded into the base itself.
When the operation is complete, damp parts should be dried thoroughly.

8.5.1 Removing guide frames

Removing the guide frames makes
it easier to clean the side parts,
and it also needs to be done
whenever the automatic cleaning
cycle is used (only available on
some models).
• To remove the guide frames,
pull the frame towards the
inside of the oven to unhook it
from its housing A, then slide it
out of the seats at the back B.
• When cleaning is complete,
repeat the above procedures to
put the guide frames back in.
47