Fill Funnel; Calrod ® Heating Element - GE EDW4000 Technical Service Manual

No Water Circulation
YES
Check for clogged:
hub (remove lower wash arm)
inlet cover
fine filter
sump/sump filter
Check pump for open/
shorted motor winding.

Fill Funnel

The fill funnel is removable with a quarter turn
clockwise. There is an O-ring seal between the fill
funnel and the dishwasher tub.
®
Calrod Heating Element
The heating element can be activated using
service mode. Refer to the
The dual wattage Calrod
835 W when it is wet to heat the water faster and,
circulation pump using
service mode (refer to Service
Mode chapter).
Does pump
Pump is stalled/clogged.
Disconnect power and
attempt to turn pump using
cooling fins.
Motor capacitor is open/
shorted.
ground-wire screw
on pump must be tightened
YES
Is L1 voltage present at pump?
Note: Perform test with
wiring connected and
L1 Output from J2-1
CIRCULATION PUMP
NX
J2-1
chapter.
Service Mode
®
heating element draws
Attempt
to activate
activate?
YES
Important:
Self tapping
securely.
pump under
load.
DOOR
INTERLOCK
WR
M
NO COM
10
Rotate clockwise 1/4 turn to remove.
– 20 –
NO
Does
the pump
hum?
NO
Check for an open
circuit between control
module and pump or
NO between pump and door
interlock switch. If
circuits OK, replace
control module.
WX
N
O-ring