Dishwasher Components; Door Components; Escutcheon Keypad Assembly - GE EDW4000 Technical Service Manual

Triton xl dishwashers

Hide thumbs Also See for EDW4000:

Owner's manual (32 pages)

Owner's manual (16 pages)

Owner's manual (16 pages)

Table Of Contents

Table of Contents

Door Components

The door components are accessible by removing

3 Phillips screws from each side of inner door and

2 T20 torx screws from the bottom of the door.

Carefully separate the inner door panel from the

outer door panel. To access the active vent,

flapper, and door interlock switch, the escutcheon

keypad assembly must be removed.

Escutcheon Keypad Assembly

The keypad and 2 ribbon cables are a permanent

part of the escutcheon and are replaced as a unit.

Disassembly

Caution: After removing the screws from the

escutcheon keypad assembly, the assembly is

still attached to the control module by 2 ribbon

cables. Dropping or rough handling of the

escutcheon will cause the ribbon cable to tear, and

the entire escutcheon keypad assembly will need

to be replaced.

1. Remove the outer door panel

nents ).

2. Open the door, support the escutcheon

keypad assembly, and remove 6 screws from

the back side of the escutcheon keypad assem-

bly.

3. Remove the 2 ribbon cable connectors from the

control module and remove the escutcheon

keypad assembly.

Assembly

IMPORTANT: When reassembling, the active vent

flapper must be closed before the escutcheon

keypad assembly is installed. Close the active vent

flapper by turning the worm gear by hand. Failure

to do so will cause a misalignment and an

increase in noise level.

1. While supporting the escutcheon keypad as-

sembly, connect the 2 ribbon cable connectors

to the control module.

2. Open the door. Align the escutcheon and install

6 screws from the back side of the escutcheon

keypad assembly.

3. Install the outer door panel

nents ).