Reviewz - GE EDW4000 Technical Service Manual

1. The incoming water temperature must be
_________.
2. The dishwasher has a ______ year parts
warranty.
The electronic module has a _____ year
_________________ warranty.
3. The dishwasher has a ______ year labor
warranty.
4. If the bearing washer (item #611) on the top
rack, bottom wash arm is left out, then:
a. washability can be affected.
b. glassware can be broken.
c. excessive wear will occur.
d. all of the above will occur.
e. none of the above will occur, the part is really
not needed.
5. Circle the button(s) which must be pushed to
enter Service Mode.
FLAT PANEL
5L 4L 3L 2L
Indicates Keypad Used Only on Some Models
BOWED PANEL
5L
3L
2L
Indicates Keypad Used Only on Some Models
START
1L 1R 2R 3R 4R
RESET
4R
3R
2R
START 1R
1L 4L
RESET
Review
6. The high drain loop, mounted on the side of the
tub, can be removed if needed.
T or F
7. A blinking START/RESET keypad light indicates:
a. Sequence switch problem.
b. Cycle was interrupted and dishwasher will
drain and stop.
c. There is a problem with the heater circuit.
d. There is a problem with the water valve
circuit.
8. A blinking Clean light indicates:
a. The unit has no water.
b. There is a problem with the turbidity sensor
circuit.
c. The water was not heated properly on sani-
cycle models.
d. Dishwasher is in Extended Wash Mode.
9. The detergent/rinse agent dispenser is activated
with _____ volts ____ times during the cycle.
10. If the turbidity sensor fails, the dishwasher
stops, beeps, drains, and terminates the cycle.
T or F
– 38 –