Table of Contents
Advertisement
3.
Select the language and click the OK button.
The setup file installs the utility.
4.
On each computer on your network that shares the USB printer, perform the initial setup of
the NETGEAR USB Control Center.
The first time you use the USB printer that is connected to your router, you are asked to
select the USB printer. For more information, see the following section,
NETGEAR USB Control
5.
(Optional) Change the default settings.
For more information, see
Set Up the NETGEAR USB Control Center
The first time you access the utility, you are asked to select the printer.
•
When a USB printer is detected and connected automatically during the initial setup, you
have to disconnect the printer and wait for the prompt asking you to click the Connect
button.
•
You might be asked to install the driver for this printer. After the driver is installed, the
printer status changes to Available.
To set up the NETGEAR USB Control Center:
1.
On each computer on your network that shares the USB printer, launch the NETGEAR
USB Control Center the same way you launch any application program on your
Windows or MAC computer.
R6200v2 Smart WiFi Router
Center.
Configure the NETGEAR USB Control Center
ReadySHARE Printer
61
Set Up the
on page 63.
Hide quick links:
Advertisement
Table of Contents
