Clarion Ungo Pro Security RK1 Installation Manual page 31

up to four remotes, a feature called individual recognition. Each time that particular remote is used
to deactivate the system, the assigned feature settings will be recalled. Individual recognition is only
possible when programming the unit via the Pro Security Programmer.
The remote coding may be locked if previously programmed using the Pro Security Programmer.
If the horn generates one long honk when attempting to program the unit, the remote coding is
locked and must be unlocked using the Pro Security Programmer before proceeding.
To program the features using the Override switch:
1. Key. Turn the ignition on and then back off.
2. Select Menu. Press and hold the Override switch. When the LED flashes once and
the horn honks Menu One has been selected. Continue to hold the switch until the
LED flashes twice and the horn honks twice Menu Two has now been selected.
Release the switch after the Menu choice has been selected.
3. Choose. Within 10 seconds, press and release the Override switch the number of
times corresponding to the feature number you want to program and then press
and hold the switch. (See Feature Menus.)
After a second, the LED will flash to indicate which feature you have accessed. For example, in Menu
Two, groups of eight flashes would indicate access to the activation pulse setting (Feature 2-8). The
horn will also honk eight times (if connected).
4. Transmit. The remote is used to select the desired setting. Pressing
change the feature to the LED ON setting (or will flash once for features with more
than 2 settings). The horn will honk once (if connected). Pressing
the setting to the LED OFF setting (or will flash two or more times for features with
more than 2 settings).
Release. The Override switch can now be released.
5.
You can advance from feature to feature by pressing and releasing the Override switch the number
of times necessary to get from the feature you just programmed to the feature you wish to access. For
example, in Menu One, if you just programmed Feature 1-2 and you next want to program Feature
1-3 to off, release the Override switch. Press and release it once to advance from Feature 1-2 to
Feature 1-3. Then press it once more and hold it. The LED will flash in groups of 3 and the horn will
honk 3 times (if connected) to confirm that you have accessed Feature 1-3.
will
will change
31