Removing A 10-Gigabit Ethernet Xfp Transceiver Module; Figure 1-42 Removing The 10-Gigabit Ethernet Xfp Transceiver - Cisco ASR 9000 Series Installation Manual

Chapter 1 Installing Line Cards in the Cisco ASR 9000 Series Router

Removing a 10-Gigabit Ethernet XFP Transceiver Module

The XFP transceiver is a static-sensitive device. Always use an ESD wrist strap or similar individual
Caution
grounding device when handling XFP transceivers or coming into contact with modules.
If you are removing an XFP transceiver, follow these steps:
Disconnect the network interface cable from the XFP transceiver connectors. Immediately reinstall the
Step 1
dust plug in the fiber-optic cable LC connector.
Pivot the XFP transceiver bale clasp up to release the XFP transceiver from the socket (see
Step 2
Slide the XFP transceiver out of the socket. Pivot the bale clasp down and immediately install the dust
Step 3
plug in the XFP transceiver optical bores (see
Immediately place the XFP transceiver in an antistatic bag.
Step 4
Figure 1-42
OL-17500-08
Removing the 10-Gigabit Ethernet XFP Transceiver
A/ L
0
A/ L
1
A/ L
0
A/ L
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
Figure 1-42).
1
Installing and Removing XFP Modules
Figure 1-42).
1-81