Figure 1-30 Mylar Tab Sfp Or Sfp+ Module; Figure 1-31 Installing A Mylar Tab Sfp Module - Cisco ASR 9000 Series Installation Manual

Installing and Removing SFP Modules
Figure 1-30
Installing a Mylar Tab SFP or SFP+ Module
To install this type of SFP or SFP+ module, follow these steps:
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 1
Line up the SFP module with the port, and slide it into place (see
Step 2
Figure 1-31 Installing a Mylar Tab SFP Module
Note When installing an SFP module, you should hear a click as the triangular pin on the bottom of the SFP
module snaps into the hole in the receptacle, indicating that the module is correctly seated and secured
in the receptacle. Verify that the SFP modules are completely seated and secured in their assigned
receptacles on the line card by firmly pushing on each SFP module.
Removing a Mylar Tab SFP or SFP+ Module
To remove this type of SFP or SFP+ module, follow these steps:
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 1
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
1-72
Mylar Tab SFP or SFP+ Module
Chapter 1 Installing Line Cards in the Cisco ASR 9000 Series Router
Figure
1
0
1-31).
3
5
7
9
2
4
6
8
OL-17500-08