2-Port 10-Gigabit Ethernet Modular Port Adapter - Cisco ASR 9000 Series Installation Manual

Chapter 1 Installing Line Cards in the Cisco ASR 9000 Series Router
Table 1-5
Table 1-5
LED Label
A/L
STATUS
Supported SFP Modules
See
operating parameters.
For more information on cabling and connectors, see the
For more information on the Gigabit Ethernet interface, cabling, and connectors, see the
Ethernet Interfaces" section on page
The 20 SFP cages support either fiber-optic or copper Gigabit Ethernet transceivers (see

2-Port 10-Gigabit Ethernet Modular Port Adapter

The 2-Port 10-Gigabit Ethernet modular port adapter provides two cages for XFP Ethernet optical
interface modules that operate at a rate of 10 Gbps. The two XFP modules can be 10-Gigabit Ethernet
multimode or single mode connections (see
Each XFP cage on the 4-Port 10-Gigabit Ethernet modular port adapter has an adjacent A/L
(Active/Link) LED visible on the front panel. The A/L (Active/link) LED indicates the status of the
associated XFP port, as described in
Refer to
OL-17500-08
describes the 20-Port Gigabit Ethernet modular port adapter LEDs.
20-Port Gigabit Ethernet Modular Port Adapter LEDs
Color
Off
Green
Amber
Off
Green
Amber
Table A-2 for a list of all SFP modules supported on the 20x1GE modular port adapter, and their
Figure 1-13 below for an example of the 2-Port 10-Gigabit Ethernet modular port adapter.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
State Meaning
Off Port is not enabled.
On Port is enabled and the link is up. The MPA A/L
(Active/Link) LED will blink green when there is traffic
activity.
On Port is enabled and the link is down.
Off Modular port adapter power is off.
On Modular port adapter is ready and operational.
On Modular port adapter power is on and good, and modular
port adapter is being configured.
1-99.
Table A-6).
Table 1-6.
Preparing for Installation
"Cabling Description" section on page 1-99.
"Gigabit
Table A-2).
1-31