InSinkErator Invite H770-SS Owner's Manual page 9

2
INSTALLING THE FAUCET - H770
A
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
B
Fiber
Gasket
Make sure to use fiber gasket
to ensure proper seal.
C
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
D
Half moon shaped metal mounting plate
should cradle all descending tubes.
H770
I I
Unpack dispenser components.
I I
On a firm, flat surface, carefully
straighten the copper tubing using
hands only.
H770
I I
Ensure that the fiber gasket is
properly seated against the base
of the dispenser head.
DO NOT remove mounting screw or
fiber gasket from base of dispenser.
H770
I I
Feed tubes down the hole in the sink
or countertop until the base is at rest
on the sink or countertop surface.
I I
Position faucet head at the
desired angle.
H770
I I
From below the sink, place semi-
circular metal mounting plate over
the mounting screw, ensuring the
mounting plate covers the sink hole.
I I
Slide washer over so that the screw
is now inside the smaller hole.
Tighten the screw until snug.
9