InSinkErator Invite H770-SS Owner's Manual page 8

2
INSTALLING THE FAUCET - H990
A
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
B
Make sure to use rubber gasket
to ensure proper seal.
C
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
8
H990
I I
Unpack dispenser components.
I I
On a firm, flat surface, carefully
straighten the copper tubing using
hands only.
H990
I I
Ensure that the black rubber gasket
is properly seated into the base of
the dispenser head and will
surround the sink mount.
I I
Feed tubes down the hole in the
sink or countertop until the base is
at rest on the sink or countertop
surface.
H990
I I
From under the sink, place the
semi-circular mounting plate onto the
threaded stud.
I I
Place wing nut onto the threaded
stud. Make sure faucet head is at the
desired angle. Tighten the wing nut
until snug, while ensuring the semi-
circular mounting plate extends
beyond the sink hole.