Start Here - InSinkErator Invite H770-SS Owner's Manual

START HERE

1
PREPARATION
A
Required minimum from
center of hole to wall
HC-View-SS ...... 2
H-View-SS ........ 2
HC-Wave-SS .... 2
H-Wave-SS ...... 2
HC3-SS ............ 2
GN3-SS ............ 2
H990-SS .......... 1
H770-SS .......... 2" ............................
,
HC3/GN3 extension is available by special order (EXT-10)
*
The wall outlet for your dispenser must have power supplied to it continuously
and must be fused. It should not be controlled by the same wall switch
that operates your disposer, unless using an InSinkErator SinkTop Switch
B
If you have to drill through sink or
countertop, you may need to rent or purchase
the appropriate tools.
C
Consult a professional before drilling into
a surface other than stainless steel.
PROPER INSTALLATION SHOULD TAKE ABOUT 2-4 HOURS
Maximum counter
thickness (depth)
5 ⁄ " ..........................3"
8
5 ⁄ " ..........................3"
8
⁄ " ..........................3"
5
8
3 ⁄ "..........................3"
8
1 ⁄ " ..........................
4
⁄ " ..........................
1
2
1 ⁄ " ..........................3"
4
Required Hole Size
1 1 ⁄ " - 1 1 ⁄ "
4 2
Dependent on model
I I
Identify locations for the dispenser
faucet, tank and filter (if applicable).
I I
Check to make sure there is proper
clearance (see chart at left) for
dispenser handles to be fully opened.
I I
Check to make sure counter is not
3 ⁄ " *
4
too thick (see chart at left).
⁄ " *
3
4
I I
Make sure there is a grounded
3 ⁄ "
4
electrical outlet under the sink.
I I
Turn off water supply.
I I
If using the sink sprayer hose hole,
remove nut that connects sprayer
hose at bottom of faucet.
I I
Using adjustable wrench, remove nut
connecting sprayer washer flange in
sprayer hole.
I I
Plug hose opening with either a 1/8"
plug or a 1/4" cap (not supplied).
What if you don't have a sprayer hole or
don't want to use it?
I I
Many homeowners replace the soap
dispenser in their sink with an instant
hot water dispenser.
I I
If drilling a hole into a stainless steel
sink or counter top, you can cut a
mounting hole for the dispenser with a
hole saw for stainless steel, or you can
use a hole punch.
TM .
5