Adjusting The Headlamps - Ford 2013 Flex Owner's Manual

2. Lift the passenger's side of the cover and push
the cover toward the passenger's side. Release the
three tabs on the cover from the three slots in the
driver's side of the housing.
3. Carefully separate the cover from the housing.
4. Remove the air filter element from the housing.
5. Wipe the cover and the housing clean to remove
any dirt or debris and to make sure the cover seals
to the housing.
6. Install a new air filter element. Be careful not to crimp the filter
element edges between the housing and the cover. This could cause filter
damage and allow unfiltered air to enter the engine if not properly
seated.
7. Lower the driver's side of the cover and slide the three tabs on the
cover into the three slots in the housing.
8. Lower the passenger's side of the cover. Engage the two clamps to
secure the cover to the housing.

ADJUSTING THE HEADLAMPS

The headlamps on your vehicle are properly aimed at the assembly plant.
If your vehicle has been in an accident, the alignment of your headlamps
should be checked by your authorized dealer.
Vertical Aim Adjustment
1. Park the vehicle directly in front of a wall or screen on a level surface,
approximately 25 feet (7.6 meters) away.
2013 Flex (471)
Owners Guide gf, 4th Printing, December 2012
USA (fus)
Maintenance 319