Ford 2013 Flex Owner's Manual page 89

88
Easy Entry and Exit Feature
When you switch the ignition off, the steering column will move to the
full up and forward position to allow extra room to exit your vehicle. The
column will return to the previous setting when you switch the ignition
on. You can enable or disable this feature in the information display.
See General Information in the Information Displays chapter.
Memory Feature
The steering column position saves when you do a memory set function.
You can recall it with the memory feature. Refer to the Seats chapter.
Pressing the adjustment control during memory recall will cancel the
operation. The column will respond to the adjustment control.
The steering column sets a stopping position just short of the end of
the column position to prevent damage to the steering column. A new
stopping position will be set if the steering column encounters an object
while tilting or telescoping.
To reset the steering column to its normal stopping position:
1. Press the steering column control again after encountering the new
stopping position.
2. Continue pressing the control until it reaches the end of the column
position.
A new stopping position will be set. The steering column will stop just
short of the end of the column position the next time it is tilted or
telescoped.
2013 Flex (471)
Owners Guide gf, 4th Printing, December 2012
USA (fus)
Steering Wheel
Use the control on the side of the
steering column to adjust the
position.
To adjust:
• tilt: press the top or bottom of the
control
• telescope: press the front or rear
of the control.