Remote Control; Keys - Ford Expedition Owner's Manual

Keys and Remote Control

REMOTE CONTROL

Integrated Keyhead Transmitters
Replacing the Battery
Note: Refer to local regulations when disposing of transmitter batteries.
Note: Do not wipe off any grease on the battery terminals or on the
back surface of the circuit board.
Note: Replacing the battery will not delete the transmitter from the
vehicle. The transmitter should operate normally.
The remote control uses one coin-type three-volt lithium battery CR2032
or equivalent.
Integrated Keyhead Transmitter
2013 Expedition (exd)
Owners Guide gf, 1st Printing
USA (fus)
Your vehicle may be equipped with
two integrated keyhead
transmitters. The key blade is used
to start the vehicle and unlock or
lock the driver's door from outside
the vehicle. The transmitter portion
functions as the remote control.
Note: Your vehicle's keys were
issued with a security label that
provides important vehicle key cut
information. Keep the label in a safe
place for future reference.
1. Twist a thin coin in the slot near the key
1
ring to remove the battery cover (1).
2. Carefully peel up the rubber gasket (2)
from the transmitter if it does not come off
2
with the battery cover.
3. Remove the old battery (3).
3
53