Schwinn SR23 Recumbent Bike Assembly Manual page 18

Step 9 Install Seat Assembly
Parts:
• seat Assembly (From steps 3 through 7)
• seat Rail (Ref. H)
• seat Rail bracket (Ref. d-)
tools:
• supplied Allen wrench
NOTE: to ease assembly, use two people for this step.
9-1 Pull out on the seat Adjustment Knob (K-3) while sliding the
seat Assembly onto the seat Rail (H). Release the Adjustment Knob to
lock the seat Assembly in place.
NOTE: make sure the seat Adjustment Knob is on the side of the
seat Rail that has the holes.
9-2 Reinstall the seat Rail bracket to the seat Rail making sure the tab of the
bracket faces forward.
9-3 Reconnect the Heart Rate wires and reinstall the seat Rail with
seat Assembly on the main unit. (Figure A)
NOTE: After reconnecting the Heart Rate wires, tuck them into
the hole in the frame to avoid pinching the wires.
9-4 connect the Heart Rate wire (m) to the jack on the junction box labeled
"HAnd Pulse". (Figure b)
NOTE: to access the Junction box you may have to loosen the knob
on the seat back, raise it upward then re-tighten the knob.
this also how you adjust the seat back to position
the lumbar support to your preference.
Figure A
D-22
H
Figure B
K-3
M
15