ProForm 525 User Manual page 8

Speed Control
CAUTION:
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing above)
whilst operating the treadmill. When the key
is removed from the console, the walking
belt will stop.
• Adjust the speed in small increments.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and use only a sealable water
bottle.
BATTERY INSTALLATION
UNPLUG THE
POWER CORD.
The console re-
quires two 1.5 V
batteries (in-
cluded). Alkaline
batteries are rec-
ommended. To in-
stall batteries, first
open the battery
cover under the console as shown. Press two batteries
into the battery compartment. Make sure that the neg-
ative (–) ends of the batteries are touching the
springs. Close the battery cover.
8
Key
Before operating the
Batteries
Cover
Monitor
Display
On/Reset Display
Button
Button
STEP-BY-STEP CONSOLE OPERATION
If there is a thin sheet of clear plastic on the console,
remove it. In addition, make sure that the power cord is
properly plugged in (see page 7).
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing above), and
slide the clip onto the waistband of your clothes. Fully
insert the key into the console. Test the clip by care-
fully taking a few steps backward until the key is
pulled from the console. If the key is not pulled
from the console, adjust the position of the clip as
needed. Then, remove the key from the console.
Follow the steps below to operate the console.
Insert the key fully into the console.
1
Inserting the key will not turn on the displays. The
displays will turn on when the ON/RESET button
is pressed or when the walking belt is started.
Note: If you just installed batteries, the displays
will already be on.
Reset the speed control and start the walking
2
belt.
Slide the speed control
to the RESET position.
Note: Each time the
walking belt is
stopped, the speed
control must be
moved to the RESET
position before the walking belt can be
restarted.
Pulse
Display
Pulse
Sensor
Clip