Positioning The Logs - Heat & Glo Soho-N-AU Installer's Manual

E. Positioning the Logs
2 2
Figure 12.2
CAUTION: Logs are fragile. Carefully remove the logs
from the packaging.
Figure 12.4
Step 1. Place Log #1 (SRV2111-700) against rear right
tab with its slot over center locating tab.
2 2
Figure 12.6
Step 3. Place Log #3 (SRV2111-702) so the top rests on
Log #1 against Log #2. The base slot on Log #3 will fi t
over the locating tab on the front right hand side.
26
3 3
1 1
1 1
1 1
3 3
Heat & Glo • SOHO-N-AU • 2197-900 Rev. C • 9/09
Log Assembly: LOGS-SOHOCE
LOCATING TABS
Figure 12.3
2 2
Figure 12.5
Step 2. Place Log #2 (SRV2111-701) onto base pan such
that Log #2 fi ts in groove of Log #1. Push it back against
the left hand side locating tab. Ensure burner ports are not
covered by logs.
DO NOT use logs other than those supplied with this appli-
ance. Contact service & spare parts for replacements.
1 1