Baumatic BDS670BL Insrtuction Manual page 32

Motor hums
Suds in the Spilled rinse aid
tub
Stained tub Detergent with
interior colourant was used
Dishes are not Rinse aid dispenser is
fully dried empty
Dishes and Improper program
pans are not
clean
Improper loading
Spots and Extremely hard water
filming on Low inlet
glasses and temperature
pans Improper loading
Improper detergent
Incorrect salt/rinse
aid levels
Steam A normal
phenomenon
Black or grey Aluminium utensils
marks on have rubbed against
dishes dishes
Water This is normal
standing in the
bottom of the
tub
Dishwasher The rinse aid
leaks dispenser is
overfilled or rinse aid
has been spilt inside
the appliance
Dishwasher isn't
level
If the dishwasher is not going to be
used for a period of time, then you
should make sure that the appliance
is set on a wash program once a
week. Otherwise the seal around
motor may dry out and cause noise.
Always wipe up any excess rinse aid
or rinse aid spillages immediately.
Use a detergent without colourant.
Make sure that the rinse aid
dispenser is filled with rinse aid.
Select a more intense wash
program.
Make sure that the spray arms and
the detergent dispenser are not
being impeded by large dishes.
Refer to the relevant sections of this
booklet, to ensure that the
detergent, salt and rinse aid levels
are set correctly. Ensure that the
appliance is loaded correctly.
You may get a small amount of
steam coming through the vent by
the door latch, during drying and
water draining.
Use a mild abrasive cleaner to
eliminate the marks. Make sure that
the appliance is loaded correctly in
future.
A small amount of clean water in the
base of the appliance is not
something to be concerned about.
Take care not to overfill the rinse aid
dispenser. Spilt rinse aid could cause
oversudsing and lead to overflowing.
Wipe away any spills immediately
with a damp cloth.
Make sure that the dishwasher is
level.
32