To Erase The Memory - Chamberlain HD920EV Manual

Remote Control
PROGRAM A REMOTE CONTROL USING THE LEARN BUTTON
1
Locate the Learn Button.
When replacing the light lens cover, ensure the antenna wires are handing straight down.

To Erase the Memory

2
Press and immediately release the Learn button. The
Learn LED will glow steady for 30 seconds. Within 30
seconds...
LEARN
LED
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1
Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds). All remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (Including MyQ™ enabled accessories)
1
Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2
Immediately press and hold the learn button again until the learn LED goes out. All codes are now
erased.
Reprogram any accessory you wish to use.
40
3
Press and hold the button on the remote control that you
wish to use.
Release the button when the garage door opener lights
blink or two clicks are heard.
LEARN
Button