Installation; Attach The Emergency Release Rope And Handle - Chamberlain HD920EV Manual

Installation

6
Install the light bulbs
To prevent possible OVERHEAT NG of the end panel or light socket:
• Use ONLY A19 incandescent or compact fluorescent light bulbs.
• DO NOT use incandescent bulbs larger than 100W.
• DO NOT use compact fluorescent light bulbs larger than 26W (100W) equivalent.
• DO NOT use halogen bulbs.
• DO NOT use short neck or specialty light bulbs.
7

Attach the emergency release rope and handle

To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
• If possible, use emergency release handle to disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced door could result in an open door falling
rapidly and/or unexpectedly.
• NEVER use emergency release handle unless garage doorway is clear of persons and
obstructions.
• NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
6.1
Pull on the top sides of the light lens and
rotate the light lens down.
6.2
Insert an A19 incandescent or compact
fluorescent light bulb (100 watt maximum),
into the light socket.
6.3
Rotate the lens up to close.
NOTE: The use of short neck or speciality light
bulbs may overheat the end panel or light socket.
7.1
Insert one end of the emergency release
rope through the handle. Make sure that
"NOTICE" is right side up. Tie a knot at
least 1 inch (2.5 cm) from the end of the
emergency release rope.
7.2
Insert the other end of the emergency
release rope through the hole in the
trolley release arm. Make sure the
handle is 6 feet (1.83 m) above the floor
and secure with a knot.
NOTE: If it is necessary to cut the emergency
release rope, seal the cut end with a match or
lighter to prevent unraveling. Ensure the
emergency release rope and handle are
above the top of all vehicles to avoid
entanglement.
16
or
or