Troubleshooting - Bissell DEEPCLEAN PREMIER User Manual

Troubleshooting

problem
Reduced
spray or
no spray
Dirtlifter
powerbrush
does not turn
cleaner
not picking
up solution
please do
not return
this product
to the store.
www.bissell.com
14
possible causes
bladder may be empty
2-in-1 tank may not be seated
properly
Pump may have lost prime.
belts are off or broken
Circuit breaker on machine may
have tripped
2-in-1 tank may not be seated
properly
2-in-1 tank may not be assembled
properly
2-in-1 water tank has picked up
maximum dirty water and red
float door has closed.
Red float "door" in tank may have
closed as a result of bumping
object or moving machine back
and forth too quickly
Red lint screen near air duct
is dirty
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a bissell product.
WARNING
To reduce the risk of electric shock, push power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Press power button
bladder with clean hand hot
(60°F/140°C MAX) tap water and
formula.
Press power button
remove and reseat tank so it
sits snugly on machine.
Press power button
after 1 minute turn on and depress
spray trigger.
Press power button
unplug unit from outlet. Follow
instructions on pages 12 and 13.
Press power button
unplug from outlet. Check to see if
foreign object is caught in brush roll.
Remove object. Plug machine in to
reset circuit breaker.
Press power button
remove and reseat tank so it
sits snugly on machine.
Make sure tank latches on both sides
of tank are latched properly.
empty 2-in-1 tank and refill, refer
to the Operation section.
Press power button
red float door to release back into
open position. Press power button
back on to continue cleaning. be sure
your forward and backward strokes
are done at a slower pace.
Follow cleaning instructions in
step 4 on page 11.
off; refill
off;
off;
off and
off and
off;
off, allowing