Release Notes, April, 2011 (Differences From Release A.10.02); Release Notes, December, 2010 (Differences From Release A.10.01); Release Notes, September, 2010 (Differences From Release A.10.00) - Agilent Technologies 86100A Release Notes

N1010A FlexDCA and 86100A/B/C/D
Firmware Release Notes
General Defects Fixed
• Fixed a defect with TDR calibrations (normalization) at long time ranges.
Known Issues
• 86119A (Optical Sampling Oscilloscope) is designed to work on software versions
A.03.06 and A.03.05 only.
A.10.03 Release Notes, April, 2011 (Differences from Release A.10.02)
General Comments
• Various improvements made to support the N1010A FlexDCA application.
• Requires Windows XP Service pack 2 or later. If you have an 86100C instrument
with Windows XP Service pack 1 installed on it, you must upgrade to Service Pack
2 before you can use firmware release A.10.03 or later.
Known Issues
• 86119A (Optical Sampling Oscilloscope) is designed to work on software versions
A.03.06 and A.03.05 only.
A.10.02 Release Notes, December, 2010 (Differences from Release
A.10.01)
New Feature List
• Various improvements made to support the N1010A FlexDCA application.
General Defects Fixed
• Fixed a defect that would cause a decrease in throughput when using the 86115D
module if one channel had the reference filter enabled while the other channel
was unfiltered.
• Fixed a defect that would cause incorrect behavior of markers on S- Parameters
when using the 86100D mainframe.
• Fixed a defect that would cause unpredictable frequency spacing when saving
Touchstone files on either the 86100C or 86100D mainframes.
• Fixed a defect that would cause measurement errors in the vertical histogram if
the histogram window encompassed the entire display.
• Various defects fixed to support the N1010A FlexDCA application.
Known Issues
• 86119A (Optical Sampling Oscilloscope) is designed to work on software versions
A.03.06 and A.03.05 only.
A.10.01 Release Notes, September, 2010 (Differences from Release
A.10.00)
New Feature List
• Various improvements made to support the N1010A FlexDCA application. In the
clock recovery event register (see 86100A/B/C/D programmer's guide), added
definition for bit 6 (FIN). The FIN bit indicates that a clock recovery relock
22