Table of Contents
Advertisement
3.
Once you have established the desired location of the thermostat,
use a pencil, and the wall plate as a template, to mark the
location of the mounting holes on your wall.
4.
Move wall plate out of the way and drill two holes using a
3/16" drill bit.
5.
Feed the thermostat wires through the rectangular hole and
fasten wall plate loosely to wall using two mounting screws in
mounting holes.
If desired, place a level against bottom of the wall plate and
adjust until level before tightening screws (leveling is for
appearance only and does not affect thermostat operation).
If you are using existing mounting holes, or if holes drilled are
too large and do not allow you to tighten base snugly, use
plastic wall anchors included with the product.
6.
Connect wires to the thermostat wall plate. The image below
shows the location of the wire terminals. Each terminal is
labeled with a letter or letter number combination.
Feed wires through
this hole from back
O/B
G
W/E
W2
L
Connect
wires here
Y2
Y1
RC
RH
Wire
C
Terminals
Wall plate
7
Advertisement
Table of Contents
