Table of Contents
Advertisement
Connect wires as follows:
If necessary, strip insulation about 3/8 inch from the end
•
of the wire.
Use the table you previously filled out on the back of the
•
installation manual (or the wiring chart on page 20) to locate
the correct terminal for each wire connection.
Bend the wire slightly, insert the wire under the contact plate,
•
and use a small flat head screwdriver to secure the wire
into place.
7.
Push excess wire into wall and plug hole with a fire resistant
material (such as fiberglass insulation) to prevent drafts from
affecting thermostat operation.
8
Fasten thermostat to wall plate using the quick connect feature.
Make sure the retention tabs on the wall plate are in line with
the retention slots on the thermostat. Gently press the
thermostat onto the wall plate until you hear a clicking sound.
If the thermostat does not easily click do not press with
excessive force or damage could occur to the product.
9.
Turn power back on at the breaker.
8
Advertisement
Table of Contents
