Rear Panel; Antenna Jack; External Speaker Jack - Vertex Standard EVX-5400 Operating Manual

Rear Panel




Antenna Jack

The 50-Ohm coaxial feedline to the antenna must be connected here, using a
mini-UHF plug.
 13.6V DC Cable Pigtail with Connector
The supplied DC power cable must be connected to this 2-pin connector. Use
only the supplied fused cable, extended if necessary, for power connection.
Replace only with the same or equivalent type fuse.


External Speaker Jack

An external loudspeaker may be connected to this 2-contact, 3.5-mm mini-
phone jack.
Caution: Do not connect either wire of this line to ground, and be certain that
the speaker has adequate capability to handle the audio output (12 W) from
the radio.
 D-Sub 15-Pin Accessory Connector
External TX audio line input, PTT (Push To Talk), Squelch, and external RX
audio line output signals may be obtained from this connector for use with ac-
cessories such as data transmission/reception modems, and external Channel
control input, etc.
6
c & c
ontrols

onnEctors

EVX-5400 O
pErating

M
anual