Assembly - Pro-Form 330rt Treadmill User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Assembly requires the included hex key
and your own phillips screwdriver
For help identifying the assembly hardware, refer to the drawings below. Note: The assembly hardware and
other small parts are packaged in separate part bags. Do not open the part bags until instructed to do so.
U-nut (105)–4
Silver Ground
Screw (87)–1
WARNING:
cord until the treadmill is completely assembled.
1. Open part bag A. Identify the Right Upright (89), which
has a large round hole near the lower end.
See drawing 1a. Slide two U-nuts (105) into the lower
end of the Right Upright (89) as shown. Insert two U-
nuts into the Left Upright (not shown) in the same
way.
See drawing 1b. Attach the Left and Right Uprights (88,
89) to the Base (71) with four 3" Bolts (2) and four 5/16"
Washers (31). Make sure that the Uprights are ori-
ented so the indicated plates are facing each other.
In addition, make sure that the Base is oriented so
the Base Pads (19) are in the location shown.
3/8" Star Washer
(45)–2
1/2" Screw (84)–2
3" Bolt (2)–4
5" Bolt (10)–2
Do not plug in the power
and adjustable spanners
5/16" Washer
(31)–4
3/4" Screw (90)–10
1
Hole
89
1b
88
Plates
89
6
.
1/4" Washer
(108)–4
Crossbar Screw (69)–2
1" Bolt (12)–6
1a
105
71
31
2
19
89
31
2
19