ProForm 300 Zle Elliptical User Manual page 22

HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must remove the right
disc cover and the right pedal disc.
Using a flat screwdriver, remove the right Disc
Cover (18).
Then, remove the M8 x 12mm Screws (81) from the
right Pedal Disc (26), and gently rotate the right Pedal
Disc out of the way.
26
81
18
Locate the Reed Switch (58). Loosen, but do not
remove, the M4 x 16mm Screw (92).
92
58
41
Next, rotate the Pulley (11) until a Magnet (41) is
aligned with the Reed Switch (58). Slide the Reed
Switch slightly toward or away from the Magnet. Then,
retighten the M4 x 16mm Screw (92).
Rotate the Pulley (11) for a moment. Repeat these
actions until the console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the right pedal disc and the right disc cover.
22
11