Table of Contents
Advertisement
Available languages
Available languages
Att
PHAnto
26
Selecting the sensitivity range
(only SKP 100 / SKP 500)
Condenser microphones require a different sensitivity range than
dynamic microphones. With the plug-on transmitters, you can
switch the sensitivity range by 20 dB.
Select the "Att" menu by pressing the
appears on the display; after a short pause the current setting –
i.e. "Att OFF" or "Att on" – is displayed.
With the
/
buttons you can now switch between two
different sensitivity ranges.
: Senitivity range 1 for dynamic microphones, "Att OFF"
flashes on the display
: Sensitivity range 2 for condenser microphones, "Att on"
flashes on the display
Press the
SET
button to return to the top menu level. The display
then switches back to the standard display.
Switching the phantom powering on/off ( only SKP 500)
The SKP 500 transmitter can supply condenser microphones with
48 V phantom powering (P 48). Please note: Dynamic microphones
can be operated in phantom powering mode without harm.
However, if no condenser microphone module is being used, you
should switch off the phantom powering. With the phantom
powering switched on, the operating time of the battery will be
reduced to approx. 5 hours.
The phantom powering can be switched on or off via the operating
menu:
Select the "PHAnto" menu by pressing the
"PHAnto" appears on the display; after a short pause the current
setting is displayed.
Press the
button to switch the phantom powering on – if you
press the
button, the phantom powering is switched off. The
new setting – i.e. "On" or "OFF" – starts flashing on the display.
Press the
SET
button to return to the top menu level. The display
then switches back to the standard display.
SET
button until "Att"
SET
button until
Advertisement
Chapters
Table of Contents
