L 1035 Twin Charger; Mains Connection; Cascading Several Chargers - Sennheiser Tourguide UHF Instructions For Use Manual

L 1035 twin charger

The L 1035 twin charger is suitable for charging BA 1035 accupacks
which are supplied with the EK 1035 receiver. The accupack is slid
onto the receiver from the side.
Accupacks ensure economical and environmentally friendly
operation of the tourguide UHF system during daily use.

Mains connection

Plug the NT 1035 plug-in mains unit into the mains and connect the
cable of the plug-in mains unit to the socket on the L 1035
charger.
The plug-in mains unit is available in different voltage variants and
plug standards (see „Accessories and spare parts" on page 55).

Cascading several chargers

When using several chargers simultaneously, we recommend
cascading them. Up to four chargers can be cascaded together to
form a charging station.
Loosen and remove the screws at the bottom of the chargers and
remove the rails from all chargers. Reconnect the rails to the first
charger so that half the length protudes. Slide the second charger
onto the protruding rails and screw down. Repeat for futher
chargers (maximum 4). Tighten the screws on all chargers (you will
have one set of rails and screws spare from the last charger, these
are not required). Power is supplied by one charger to the other via
the rails .
The NT 1035 plug-in mains unit can power up to four L 1035
chargers.
12