Plugging The Plug-On Transmitter Onto A Microphone; Operation And Battery Status Indication - Sennheiser Tourguide UHF Instructions For Use Manual

Plugging the plug-on transmitter onto a microphone

Plug the transmitter's XLR-3F socket
XLR-3M socket.
Tighten the locking ring
Note:
The transmitter uses the microphone body as an antenna –
therefore only microphones with a metal casing should be used
for best signal transmission.

Operation and battery status indication

Die rote LED (LOW BAT/ON)
Betriebszustand des Senders:
Red LED lit up: The plug-on transmitter is switched on and the
capacity of the batteries/BA 2015 accupack is
sufficient.
Red LED flashing: The batteries are/the BA 2015 accupack is
going flat (LOW BAT)!
onto the microphone's
as shown.
informiert Sie über den
43