Connecting External Audio Devices - Sennheiser EMP 2015 Instruction Manual

2 mono audio devices
1 stereo audio device
2 stereo audio devices

Connecting external audio devices

You can connect two mono or two stereo audio devices to the amplifier.
Connect the RCA plugs of the sound recording devices to the RCA sockets
(LINE IN) at the rear of the EMP 2015. For correct connection of the
different audio devices, please refer to the diagrams at the left.
Note:
Stereo (left-right) signals are mixed in the amplifier and are then available
as a mono signal.
If possible, set stereo audio devices to "mono" operation. If sound
problems occur, use the left channel of TVs and VCRs.
Adjusting the volume of an external audio device
You can adjust the volume of the connected audio device (e.g. VCR) separately
from the volume of the speaker's microphone. If, however, you have connected
two audio devices to the line input, the volume control adjusts the volume of
both devices.
Use the volume control (LINE IN)
connected device.
Note
If the audio signal sounds distorted, reduce the sensitivity of the system
with control . If control
the audio signal may not be audible.
to adjust the volume of the
is turned counterclockwise as far as possible,
51