Connecting Sound Recording Devices - Sennheiser EMP 2015 Instruction Manual

2 mono sound recording devices
1 stereo sound recording device

Connecting sound recording devices

You can connect sound recording devices (e.g. tape recorder, dictating
machine, etc.) to the RCA sockets (LINE OUT)
connected device records the same signal that can be heard in the room
through the loudspeakers. If possible, connect the sound recording device
via its line input (LINE IN, REC. IN, AUX IN, TB IN or similar).
Connect the RCA plugs of the sound recording devices to the RCA sockets
(LINE OUT) at the rear of the EMP 2015. For correct connection of
the different audio devices, please refer to the diagrams at the left.
Adjusting the recording level
The recording level is independent of the setting of the volume controls
and . It is, however, dependent on the setting of the line input sensitivity
control (LINE IN) . Control
audio device.
The recording level of the line output
(corresponds to minus infinite to up to 0 dBU).
1. The sound recording device is connected via its line input (LINE IN,
REC. IN, AUX IN, TB IN or similar):
Turn control clockwise as far as possible and adjust the input level
of the sound recording device.
2. The sound recording device is connected via its microphone input:
Set the input level of the sound recording device to maximum and
use control to adjust the recording level so that, during loud
passages, distortion is avoided.
Note:
If control is turned counterclockwise as far as possible, no audio signal
will be available at the line output
If you have connected two mono sound recording devices, the control adjusts
the recording level of both devices.
of the amplifer. The
adjusts the input level of the connected
can be adjusted from 0 to 700 mV
.
rms
55